Skip to content
English
  • There are no suggestions because the search field is empty.

Bosch MEVD17.2.5 - TC1797

Bosch MEVD17.2.5 - TC1797 | bFlash FAQ

Bosch MEVD17.2.5 - TC1797

Errors

Files not found

The requested file is missing from our server database for this specific ECU version.

View Solution →

Checksum is invalid. error code : 0x00000001

A mismatch in the file's data integrity check was detected, often due to previous tuning.

View Solution →

Concerns vehicles from

BMW Logo

Files not found

Method: OBD / Recovery: Bench

Issue: The bFlash server could not locate the virtual read file required for your BMW OBD operation.

Solution
  • Switch the connection method from OBD to BENCH.
  • Perform a full read of the ECU in Bench mode to extract the local data.
  • Send the generated file to support@bflash.eu.
  • Our team will manually process the file and add it to the server for future use.
To understand more

Virtual reading relies on a pre-existing database of stock files on the server. If your specific Software ID or Hardware version has not been encountered before, a physical Bench read is necessary to map the ECU's memory structure and provide the correct flash data.

Checksum is invalid. error code : 0x00000001

Method: BENCH

Issue: The ECU reports that the file signature or Checksum does not match expected values during the verification process.

Solution
  • In most scenarios involving BOSCH MEDC17/MEVD17, you can safely ignore this warning and proceed with programming.
  • If the error persists or prevents the programming process from finishing, do not attempt further writes.
  • Contact our technical support immediately with the error log if the operation fails.
To understand more

This error typically triggers when the ECU has been previously flashed using a different tool that calculated the Checksums differently. While bFlash identifies the discrepancy, it is usually capable of correcting or bypassing the issue during the Write phase to restore data integrity.