Skip to content
English
  • There are no suggestions because the search field is empty.

Siemens SID310 - TC1791

Siemens SID310 - TC1791 FAQ & Troubleshooting

Siemens SID310 - TC1791

Errors

Quickly identify and resolve common communication issues encountered during the tuning of the Siemens SID310 control unit.

7F-10-22

The ECU refuses programming mode due to unmet environmental or external vehicle conditions.

View Solution →

Password file not found

Communication cannot proceed because the necessary decryption password hasn't been extracted from the ECU.

View Solution →

Concerns vehicles from

Dacia Nissan Renault

7F-10-22

Method: OBD

Issue: Your bFlash interface is unable to trigger the programming routine because the ECU's safety conditions have not been satisfied.

Solution
  • Open the HELP section of the Siemens SID310 protocol in bFlash.
  • Verify that all pre-requisites (e.g., battery voltage > 12.5V, engine off, ignition on) are met.
  • Ensure the vehicle is in a stable state with no active cooling fans or high-drain accessories running.
To understand more

Modern Siemens SID310 units utilize complex safety logic to prevent accidental data corruption. The 7F-10-22 error is a standard "Conditions Not Correct" response, meaning the ECU's internal diagnostics are blocking the Programming Session because the environment is deemed unsafe for writing.

Password file not found ! Please read password first

Method: OBD

Issue: The read or write operation failed because the security password required to unlock the Infineon TriCore memory is missing.

Solution
  • Navigate to the protocol and click the "Password" button.
  • Wait for bFlash to successfully extract and save the security key.
  • Once the password is stored, proceed with your intended Read/Write operation.
  • If the extraction fails: Contact our technical support.
To understand more

The Infineon TC1791 processor inside the SID310 is protected by a Tuning Protection mechanism. bFlash must first compute a specific algorithm to retrieve a unique password from the ECU's security zone before it can access the Maps or Firmware areas via OBD.